ccna post

ccna post..434.Cisco Networking Lab CCNA Lab Guide (Release 2)R1 (config-pmap)#class MAPI R1 (config-pmap-c)#bandwidth percent 30 reserves 30 percent of the bandwidth for this class/R1 (config-pmap-c)#class MAPIbandwidth {bandwidth_ycdue | percent percent_value | percent remaining remain_percent_yalue} command parameters have the following meanings: bandwidth_value: The specified specific bandwidth in kbps. percent value: The percentage of the specified interface bandwidth. remain_percent value'. Specifies the percentage of the remaining bandwidth of the interface.dad [Note].You cannot mix the bandwidth, bandwidth percent, and bandwidth remain percent commands in the same policy-map.R1 (config-pmap-c)#queue-limit 128 Define the queue length Rl(config-pmap-c)#fair-queue 256 Queue is scheduled with WFQ and the maximum number of sessions allowed is 256 RI (config-pmap-c)#exitR1 (config-pmap)#class MAP2 R1 (config-pmap-c)#bandwidth percent 10 R1 (config-pmap-c)#exit R1 (config-pmap)#class class-default Rl(config- pmap-c)#fair-queue 128 queue using WFQ scheduling, the maximum number of sessions allowed is 128 R1 (config-pmap-c)#exit R1 (config-pmap)#exit R1 (config)#interface Serial0/0/0 Rl(config-if )#bandwidth 1024// Configure the bandwidth of the interface to 1 024 kbps R1 (config-if)#service-policy output Pl Apply the policy-map to the interface, note: CBWFQ can only be applied in the outgoing direction of the interface(1) Check the configured