cisco ccna 640-878 spngn2

cisco ccna 640-878 spngn2.You should now be able to configure static address translation more comfortably on the router. Hands-on Exercise 22.2Configuring Dynamic Address TranslationIn Hands-On Exercise 22.1, you configured static translation; in this exercise, you will configure dynamic address translation. You will use the BosonNetSim simulator to complete this experiment. For a diagram of the network used by the BosonNetSim simulator, see the Preface section of this book. In this exercise, you will first configure static routes on two routers (2600-1 and 2600.2) and check network connectivity; then, configure address translation. Start this simulator and click the tab Labs9 in the lower left corner of the window Then, click the tab McGraw-Hill in the upper left corner (tab Standard and Custom to the right) and double-click Exercise22-2,which will load the experimental configuration based on the exercises in Chapters 10 and 15.1. Configure a static route to 192.168.1.0/24 via router 2600-1 on router 2600-2. View the routing table. Click the tab Lab Instructions and select 2600-2 from the drop-down list Devices; you can also click the tab NetMap, and then double-click the device icon 2600-2o configure a static route: configure terminalip route 192.168.1.0 255.255.255.0192.168.2.1 and end. to view the static route: show ip route, confirm that 192.168.1.0/24 appears in the routing table as the static route(s).2. on router 2600-1 _h,configure a static route to 192.168.3.0/24 via router 2600-2. View the routing table. Click the tab Lab Instructions and select 2600-1 from the drop-down list Devices; you can also click the tab NetMap, and then double-click the device icon 2600-1o configure a static route: configure terminal, ip route 192.168.3.0 255.255.255.0192.168.2.2 and end. to view the static route: show ip route,confirm 192.168.3.0/24appears in the routing table as static route(s).3. ping the interface fa0/0o of router 2600-1 at Host-3 pingHost-l0 Click the tab Lab Instructions and select Host-3 from the drop-down list Devices; you can also click the tab NetMap, and then double-click the device icon Host-3o ping router 2600 pingHost-1: ping 192.168.2.1 and ping 192.168.1.1, these operations should be successful. pingHost-1: ping 192.168.1.10, which should be successful.4. On router 2600-2, configure a static route to 10.0.0.0/8, which is the global address located behind router 2600-1. Remove the static route 192.168.1.0/24. Click the tab Lab Instructions, and select 2600-2 from the drop-down list Devices; you can also click the tab NetMap, and then double-click the device icon 2600-2o On router 2600-2, configure a static route: configure terminal and ip route