ccna 200 301 syllabus of upsc pdf in hindi

ccna 200 301 syllabus of upsc pdf in hindi.update, unicast update, default route, floating static route, etc. Many of these configurations are also applicable to RIPv2o1. Basic ConfigurationRIP is used here to complete the network interconnection as shown in Figure 5-2-1. Router R1 is configured as follows.Router>en Routerfrconft Router(config)#host R1 R1(config)#nocdp runThe purpose of disabling the CDP protocol is to disable the Ethernet port duplex mismatch message in the emulator to avoid being disturbed by the message.R1(config)#int sl/1 Rl(config-if)#ip add 12.1.1.1 255.255.255.0 R1(config-if)#no shut R1(config-if)#intfa0/0 -R1(config-if)#ip add 13.1.1.1 255.255.255.0(config-if)#no shut R1(config-if)#int loO R1(config-if)#ip add 1.1.1.1 255.255.255.0 R1(config-if)#exit R1(config) #router rip Configure the RIP protocol ,start the routing process. R1(config-router)#network 1.0.0,0The network command is required because it allows the routing process to determine which interfaces will be involved in sending and receiving routing updates. The network command initiates the routing protocol on all interfaces on the router that are located within a particular network , and the network command also causes the router to publish that network . ^Loopback interface of the directly connected network , RTE uses a classful address when configuring the network address , even if the configuration is 1. even m.L When you use the shbw runnMqygfig command to look at the configuration , you find that the configuration is automatically changed to 1.00 0 , if the router has multiple interfaces belonging to 1 . 0.0,. If the router has more than one interface belonging to 1.0.0, this class A network does not need to look out of the L0.0.Q dream times, once is enough . R1 (config-router)#net 12.0.0.0 Declare the directly connected network of the interface on Sl/. R1 (config-router)#net 13.0.0.0 Declare the directly connected network dish for the E&Q/Q interfaceRouter>en Router#conft Router(config)#host R2 R2(config)#int sl/1 R2(config-if)#ip add 23.1.1.2 255.255.255.0 R2 (config-if)#no shut R2(config- if)#intsl/0 R2(config-if)#ip add 12.1.1.2 255.255.255.0 R2(config-if)#noshut R2(config-if)#intloO R2(config-if)#ip add 2.2.2.2255.255.255.255.0 R2(config-if)#router rip R2(config-router)#net2.0.0.0 R2(config-router)#net12.0.0.0 R2(config-router)#net23.0.0.0163 A