ccna 200 301 syllabus of errors summary of macbeth

ccna 200 301 syllabus of errors summary of macbeth.I!; JI Success rate is 100 percent(5/5), round-trip min/avg/max = 12/21/40 ms As you can see from the above output, R1 can successfully reach the 12.1.1.2o company Example 3: Packet from R1 to 172.16.3.1.Q Note: Because Cisco routers use fast switching by default, the use of fast switching will lead to conclusions that are inconsistent with the previous narrative. Before you begin testing, turn off fast switching on router R1 using no ipcef and use process switching.The preceding lookup process is similar to Example 2, and the next lookup finds: No match found in subroutes. Look at whether router R1 is performing classful or classless routing behavior. Use the following command on router R1 to have router R1 perform classful routing behavior.R1(config)#no ip cef R1(config)#no ip classless Configure the Loopback 2 interface on R2 with an IP address of 172.1631/24. on R1 ± ping 172.16.3.1, which displays the following.Rl#ping 172.16.3.1Type escape sequence toabort. sending 5, 100-byteICMP Echos to 172.16.3.1, timeoutis 2 seconds:Success rate is 0 percent(0/5)As you can see from the above output, R1 is unable to reach 172.163.lo Use the following command on router R1 to get router R1 to perform classless routing behavior: R1(config)#ip classless Because ipclassless is the default configuration, it is not visible when shownm is running. Now router R1 performs classless routing behavior and cannot find theAfter subnet routing, continue to look for a level 1 route and find a default route, which is used to forward packets. Continue to ping 172.16.3.1 on router R1±, which displays the following: Rl#ping 172.16.3.1