ccna 200 301 o wendell odom 2019

ccna 200 301 o wendell odom 2019.Neighbor ID 1.1.1.1 Pri State 0 FULL/ - Dead Time Interface ID 00:00:35 6 Interface Serial0/0/lR2# show ipv6 ospf Interface g0/0 GigabitEthernet0/0 is up, line protocol is up Link Local Address FE80::FF:FE00:2, Interface ID 3 Area 23, Process ID 2, Instance ID 0, Router ID 2.2.2.2 Network Type BROADCAST, Cost: 1364 Chapter 17 Implementing IPv6 OSPF Example 17-10 (continued)Transmit Delay is 1 sec,State DR, Priority 1DesignatedRouter (ID) 2.2.2.2, local address FE80::FF:FE00:2No backup designated router on this networkTimer intervals configured, Hello 5, Dead 20, Wait 20, Retransmit 5These two commands listed in Example 17-10 confirm that R2 and R3 are no longer neighbors on the LAN. However, as with the similar OSPFv2 example in Chapter 11, the router does not issue a syslog message telling us the root cause of the problem. The only way to find out about this particular mismatch, via the show command, is to use the show ipv6 ospf interface command to look at both routers. Example 17-10 gives an example of R2, listing the new values 5 and 20 for the Hello and dead routers.OSPFv3 LSDB and LSAOnce OSPFv3 routers become neighbors, they exchange their LSDBOs over the subnet In most cases, the two routers exchange their LSDBs directly, and each router lists its neighbors as it reaches the Ell state. Once in the ftdl state, both routers should have the same link state broadcast in that area.