200-301 book warez

200-301 book warez.46 Chapter 2 Configuring the Spanning Tree Protocol (STP )how to use these terms for final exam preparation. Quick PVST+,PVST+, system ID extension, PAgP, LACP, port channel, and channel group.Command Reference to check your memoryThe table in this section is a reference list of configuration and EXEC commands that appear in this chapter, but there is no need to memorize the contents of the table; in fact, you should be able to remember these commands after reading this chapter and completing all the exercises in the Exam Preparation section of this chapter. To verify your learning, you can test whether you remember the commands by covering the left side of the table with a piece of paper and then reading the instructions on the right side of the table to see if you can write the corresponding commands.Table 2-4 Chapter 2 Configuration Command ReferenceCommand Descriptionspanning-tree mode ( pvst | rapid-pvst| mst} Set the global configuration commands for STP modespanning-tree vlan vlan-number root primary The global configuration command to change the switch to the root switch. When this command is issued, the switch's priority is changed to a lower priority than that of the current root bridge 24576 or 4096spanning-tree vlan vlan-number root secondary The global configuration command to set the switch STP base priority to 28672spanning-tree [vlan vlan-id\ (priority priority} The global configuration command to change the switch's bridge priority for a specific VLAN